Reinforced Welded Wire Mesh is manufactured by fully automatic and intelligent production line under the strict quality control of the factory. Grid size, rebar specifications and quality are all strictly controlled. The omission of the artificial help net is avoided. Bundling errors and cut corners occur. The mesh has large steel, good elasticity, uniform and accurate spacing, and high welding point strength. Thus greatly improving the quality of the project.
The longitudinal and transverse bars of the Concrete Reinforcing Mesh form a network structure, so it has good adhesion and anchorage with concrete, and the load is evenly distributed. This significantly improves the seismic crack resistance of reinforced concrete structures. Bridge Reinforcement Steel Mesh can improve the rigidity. According to actual tests, the laying of welded steel mesh on roads can reduce the occurrence of cracks by more than 75% compared to artificial netting.
According to the principle of equal strength replacement, and considering comprehensive factors, the use of reinforcing steel mesh can save more than 30% of the amount of reinforcing steel used. And the reinforcement mesh needs to be processed after being transported to the construction site, so there is no loss.
the use of reinforced welded mesh can make the project construction faster. As long as the reinforced welded mesh is laid as required, the concrete can be poured, eliminating the need for on-site cutting of the reinforcement, placing them one by one, and tying up. It can save 50%-70% of man-hours, greatly speed up the construction schedule and shorten the construction cycle.
50% -70% less than the binding net. With a relatively tight reinforcement distance, the longitudinal bars and cross bars of the Reinforcement Mesh form a net-like structure to bond and anchor together, which is beneficial to avoid Occurrence and development of concrete cracks. Welded mesh of road, floor, and floor equipment can reduce cracks on the concrete surface by about 75%.
the mesh size of the welded mesh is very regular, much larger than that of hand-stitched mesh, the mesh has large rigidity and good elasticity, and the steel bar is not easily bent, deformed and slipped when the concrete is irrigated. The thickness of the concrete protective layer is easy to control and uniform, which obviously improves the quality of reinforced concrete engineering.
The planned strength of welded wire reinforcement is 50% higher than that of Grade I rebar to 70%. It is still possible after considering some structural requirements. It saves about 30% of the reinforcing steel, and the processing cost of the loose steel reinforcement with a diameter of less than 12mm is about 10% ~ 15% of the material cost. Inductive consideration can reduce the cost of the reinforcing steel project by about 10%.