• welded wire mesh 100x100mm
  • Home
  • Step-by-step guide to installing T-posts

May . 23, 2024 16:14 Back to list

Step-by-step guide to installing T-posts

Step 1: Establish your corners

When installing metal fence posts, the first step is to establish the fence line’s corners and gates with wooden fence posts. Metal wire fences place a great deal of tension on the ends of an enclosure. To stand up to the pressure, fence corners and gates are best built with a solid wood fence post set in concrete and braced. 

Step 2: Line up and space the posts

With the corners set and braced, run a guideline between them to ensure the T-posts are placed in a straight line. Use a tape measure to make sure there’s even spacing between the posts. A general guideline for metal fence post spacing is to set them 8-12 feet apart; 10-12 feet is sufficient for a five- to six-strand barbed wire fence. Before you begin installation, lay the posts on the ground around the guideline to verify spacing and the number of posts needed.   

Step 3: Position the posts

Position each T-post with the anchor plate at the bottom and perpendicular to the fence line. Which way the T-posts face depends on if you want to keep livestock in or predators out. Face the T-posts with the studs inward if animals will be putting more pressure against the inside of the fence. If animals will be putting more pressure on the outside of the fence, direct the studs outward.

 

STEEL FENCE

 

Step 4: Drive the posts into the ground

To keep animals from pulling the posts out of the ground, drive the posts into the ground deep enough to completely bury the anchor, about 18-24 inches deep. A post driver — a weighted pipe that slides over the top of a T-post — works best, but a sledgehammer or regular hammer works in a pinch. As the installation progresses, move along the fence line to ensure the anchors are in a straight line.

Step 5: Install the wire

Wire tension is essential to keep livestock inside — and predators outside — a fence. Stretch the metal fencing by securing it at a corner with a few staples, leaving 18-24 inches of excess wire on the end. Wrap it around the mainline to guarantee a strong connection. On the opposite corner, use a come-along to pull the wire tight, secure it with a few more staples, and wrap the excess wire around the post. Avoid over-tightening—the wire should be taut but not guitar-string tight. 

Step 6: Add wire clips

Installing T-post clips keeps the fence wires from moving up and down and prevents them from getting pulled away from the posts. Set the wire clips in a stud on the T-post, hooking the wire with one side of the clip and wrapping the other side of the clip around the wire using a pair of fence pliers. 

Barbed wire fence posts and other types of metal fencing are affordable, easy to install, and durable. This type of fence can be used for:

  • Keeping livestock, like cattle, contained
  • Preventing predators from getting at livestock 
  • Fending off pests, like deer, from gardens 
  • Dividing different properties 
  • Providing a play area for pets 
Share

If you are interested in our products, you can choose to leave your information here, and we will be in touch with you shortly.


en_USEnglish